M-bond 610 Curing Agent, Kit Component, Curing Agent, MSDS

Home Page

Material Safety Data Sheet

Product No. 16039 M-Bond 610 Curing Agent, Kit Component:

Issue Date (10-21-05)

Review Date (05-14-07)

Section 1: Product and Company Identification

Product Name: M-Bond 610 Curing Agent

Manufacture/Vendor: Vishay Micro-Measurements, Raleigh, NC 27611

Synonym: None

Company Name

Ted Pella, Inc. and PELCO International, P.O. Box 492477, Redding, CA 96049-2477
Domestic Phone (800) 237-3526 (Mon-Thu. 6:00AM to 4:30PM PST; Fri 6:00AM to 4:00PM PST)

International Phone (01) (530) 243-2200 (Mon-Thu. 6:00AM to 4:30PM PST; Fri 6:00AM to 4:00PM PST)

Chemtrec Emergency Number 1-800-424-9300 24 hrs a day.

Section 2: Composition / Information on Ingredients

Principle Hazardous Component(s) (chemical and common name(s)) (Cas. No)	%	OSHA PEL mg/m3	ACGIH TLV mg/m3	NTP	IARC	OSHA regulated
Tetrahydrofuran (109-99-9)	88.25	200 ppm	200 ppm	No	No	No
1,2,4,5-Benzenetetracarboxylic Dianhydride (89-32-7)	8.8	NE	NE	No	No	No
1,2,4,5-Benzenetetracarboxylic Acid (89-05-4)	2.95	NE	NE	No	No	No

Note: 1,2,4,5-Benzenetetracarboxylic Acid (89-05-4): 0.25 mg/m3 Respirable Dust per manufacturer

Section 3: Hazard Identification
Emergency overview

Appearance: Colorless to amber liquid

Immediate effects: May cause severe irritation or burns. May cause vomiting, nausea, dizziness, narcosis, respiratory failure, low blood pressure, central nervous system depression, coughing and difficult breathing and/or loss of consciousness.

Potential health effects

Primary Routes of entry: Inhalation; accidental skin contact and ingestion.
Signs and Symptoms of Overexposure: Acute over-exposure may induce narcosis and/or loss of consciousness. May be a skin sensitizer to some individuals.
Eyes: May cause severe irritation or burns, tearing, and redness.

Skin: May cause severe irritation or burns, defatting, and dermatitis.

Ingestion: May cause headache, nausea, vomiting, dizziness and gastrointestinal irritation.

Inhalation: May cause headache, vomiting, nausea, dizziness, narcosis, respiratory failure, low blood pressure, central nervous system depression, coughing and difficult breathing and/or loss of consciousness.

Chronic Exposure: Chronic over-exposure may include kidney and/or liver damage.

Chemical Listed As Carcinogen Or Potential Carcinogen: None listed

See Toxicological Information (Section11)

Potential environmental effects

See Ecological Information (Section 12)

Section 4: First Aid Measures
If accidental overexposure is suspected

Eye(s) Contact: Immediately flush eyes with copious amounts of water for 15 minutes while holding eyelids open.

Skin Contact: Immediately flush thoroughly while removing contaminated clothing. Wash affected area with soap and water. Wash contaminated clothing before reuse.
Inhalation: Remove to fresh air. If breathing is difficult, administer oxygen. If breathing has stopped, administer artificial respiration and/or oxygen. Get medical attention if needed.

Ingestion: If swallowed wash out mouth with water provided person is conscious. Continue to give large quantities of water. Do NOT induce vomiting. Get medical attention.

Note to physician

Treatment: ND

Medical Conditions generally Aggravated by Exposure: Skin disorders, respiratory system disease.

Section 5: Fire Fighting Measures
Flash Point: 6 °F (-14 °C) Methods: PMCC
Flammable Limits: LEL: 1.8. UEL: 11.8

Auto-ignition point: ND
Fire Extinguishing Media: Alcohol foam, dry chemical, carbon dioxide. Water may be ineffective.
Special Fire Fighting Procedures: Firefighters should wear proper protective equipment and self-contained breathing apparatus. Cool fire-exposed containers.
Unusual Fire and Explosion Hazards: Vapors may flow along surfaces to distant ignition sources and flash back. Sealed containers may explode when exposed to high heat. Strong oxidizers can cause ignition.

Hazardous combustion products: Oxides of carbon, explosive peroxides.

DOT Class: Flammable Liquids, n.o.s.

Section 6: Accidental Release Measures
Steps to be Taken in Case Material is Released or Spilled: Remove all sources of ignition. Wipe up with absorbent material such as sand or vermiculite. Flush affected area with water.
Waste Disposal Methods: Dispose of waste according to Federal, State and Local Regulations.

Section 7: Handling and Storage
Precautions to be Taken in Handling and Storage: Store in a dry, well ventilated, flammable liquid area. Keep containers tightly sealed. Avoid prolonged exposure to vapors and skin contact.

Storage temperature: Below 80 °F (27 °C)

Storage Pressure: ND

Section 8: Exposure Controls / Personal Protection
Engineering Controls

Ventilation required: Local and general mechanical exhausts are required to keep concentrations below TLV.

Personal Protection Equipment

Respiratory protection: Respiratory protection required if airborne concentration exceeds TLV. At concentrations up to 1000 ppm, a cartridge respirator is recommended. Above this level, a self-contained breathing apparatus is recommended.

Protective gloves: Neoprene gloves are recommended.
Skin protection: Impervious over-clothing as needed.
Eye protection: Chemical splash goggles are recommended.
Additional clothing and/or equipment: Safety shower and eye wash station in local area.

Exposure Guidelines

See Composition/Information on Ingredients (Section2)

Section 9 Physical and Chemical Properties
Appearance and Physical State: Colorless to amber liquid

Odor (threshold): Ether-like

Specific Gravity (H2O=1): 0.9

Vapor Pressure (mm Hg): 145 @ 59 °F (15 °C)

Vapor Density (air=1): 2.5

Percent Volatile by volume: 705 g/liter

Evaporation Rate (butyl acetate=1): 14.5

Boiling Point: 151 °F (66 °C)

Freezing point / melting point: NA
pH: ND
Solubility in Water: Complete
Molecular Weight: ND

Section 10: Stability and Reactivity
Stability: Stable
Conditions to Avoid: Heat, sources of ignition.

Materials to Avoid (Incompatibility): Strong oxidizing agents, acids, bases, alcohol, water.
Hazardous Decomposition Products: Oxides of carbon, explosive peroxides.
Hazardous Polymerization: Will not occur.

Section 11: Toxicological Information

Results of component toxicity test performed: Tetrahydrofuran (109-99-9): IPR Rat LD50: 2900 mg/kg. INHAL Rat): LD50: 78 g/m³. 1,2,4,5-Benzenetetracarboxylic Anhydride (89-32-7): Oral, MUS LD50: 2400 mg/kg.

Human experience: ND

This product does not contain any compounds listed by NTP or IARC or regulated by OSHA as a carcinogen.

Section 12: Ecological Information

Ecological Information: ND

Chemical Fate Information: ND

Section 13 Disposal Considerations

RCRA 40 CFR 261 Classification: Tetrahydrofuran (109-99-9): U213.

Federal, State and local laws governing disposal of materials can differ. Ensure proper disposal compliance with proper authorities before disposal.

Section 14: Transportation Information

US DOT Information: Proper shipping name: Flammable Liquids, n.o.s. (Tetrahydrofuran)

Hazard Class: 3

Packaging group: II

UN Number: UN1993

Limitations: ND

Note: When ship as Kit the Proper shipping name: Chemical Kits, UN3316, Class 9, Packing Group II

IATA: Proper shipping name: Flammable Liquids, n.o.s. (Tetrahydrofuran)

Hazard Class: 3

Packing group: II

UN Number: UN1993

Limitations: ND

Note: When shipped as Kit the Proper shipping name: Chemical Kits, UN3316, Class 9, Packing Group II

Domestic shipments only: NA

IMO: Proper shipping name: Flammable Liquids, n.o.s. (Tetrahydrofuran)

Class: 3

UN Number: UN1993

Packing group: II

EMS: ND

MFAG: ND

Marine Pollutant: No

Canadian TDG: ND

IMDG Page: ND

Limitations: ND

Section 15: Regulatory Information

United States Federal Regulations

MSDS complies with OSHA’s Hazard Communication Rule 29, CFR 1910.1200.

SARA: ND

SARA Title III: Section 313: None listed.

RCRA: Tetrahydrofuran (109-99-9): U-series.

TSCA: All components of this product are listed in the Toxic Substance Control Act Chemical Substance Inventory (TSCA).

CERCLA: Tetrahydrofuran (109-99-9): RQ = 1000 lbs (454 kg).

State Regulations

California Proposition 65: Not listed.

International Regulations

Canada WHMIS: This product contains materials listed on the CPR Inventory List.

Europe EINECS Numbers: Tetrahydrofuran (109-99-9): EINECS#: 203-726-8. 1,2,4,5-Benzenetetracarboxylic Dianhydride (89-32-7): EINECS#: 201-898-9. 1,2,4,5-Benzenetetracarboxylic Acid (89-05-4): EINECS#: 201-879-5.

Section 16: Other Information

Label Information: ND

European Risk and Safety Phrases: ND

European symbols needed: ND

Canadian WHMIS Symbols: ND

HMIS® Hazard Rating: Health: 3; Flammability: 3; Reactivity: 3
(0=least, 1=Slight, 2=Moderate, 3=High, 4=Extreme)

Abbreviations used in this document

NE= Not established

NA= Not applicable

NIF= No Information Found

ND= No Data

Disclaimer
Ted Pella, Inc. makes no warranty of any kind regarding the information furnished herein. Users should independently determine the suitability and completeness of information from all sources. While this data is presented in good faith and believed to be accurate, it should be considered only as a supplement to other information gathered by the user. It is the User's responsibility to assure the proper use and disposal of these materials as well as the safety and health of all personnel who may work with or otherwise come in contact with these materials.

MSDS Form 0013F1 V2