Home Page
Material Safety Data Sheet

Prod. No's. 15718, 15719 Enhancer - Silver Enhancement Kit Component
Issue Date (date not available)

Section 1: Product and Company Identification

Product Name: Enhancer - Silver Enhancement Kit Component

Chemical Name: Proprietary mixture
UN Hazard Classification: NR
UN No.: NA
Chemical Abstract No.: NA

Company Name

Ted Pella, Inc. and PELCO International, P.O. Box 492477, Redding, CA 96049-2477
Domestic Phone  (800) 237-3526 (Mon-Thu. 6:00AM to 4:30PM PST; Fri 6:00AM to 4:00PM PST)

International Phone (01) (530) 243-2200 (Mon-Thu. 6:00AM to 4:30PM PST; Fri 6:00AM to 4:00PM PST)

Chemtrec Emergency Number 1-800-424-9300 24 hrs a day.

Section 2 Hazardous Ingredients:
Components >1% content: Sodium Sulfite 2% of total content.
Toxicity Data: LD50 820mg lkg oral, mouse
Carcinogenicity: No evidence
Mutagenicity: Evidence of mutagenic effects.

Section 3 Physical and Chemical Characteristics:
Boiling Point: Not known
Melting Point: Not known
Specific Gravity: Not known
Solubility/Water: Miscible in all proportions
Description: Colorless liquid

Section 4 Health Hazard Information:
Acute Effects:
Eye Contact: Irritant
Skin Contact: Irritant
Inhalation: Irritant
Ingestion: Causes severe internal irritation and damage. If ingested in large quantities, can cause colic, diarrhea, central nervous system depression and death, due to libration of sulphur dioxide and sulphurous acid.
Special Note: Repeated exposure may cause sensitization.

Section 5 Fire and Explosion Hazard Data:
Flash Point (method used): NA
Flammable Limits: NA
Extinguishing Methods: Compatible with surrounding conditions.
Special Fire Fighting Procedures: Wear respirator and protective clothing.

Section 6 Emergency and First Aid Procedures:
Eye Contact: Irrigate with copious amounts of water for at least 15 minutes. Assure adequate flushing by separating the eye lids. Seek medical advice.
Skin Contact: Wash contaminated area thoroughly. Remove contaminated clothing and wash before reuse. In case of extreme exposure, or if symptoms persist call a physician.
Inhalation: Remove from exposure, rest and keep warm. In case of serious exposure or if symptoms persist, call a physician.
Ingestion: If person is conscious wash out mouth with water, call a physician.

Section 7 Reactivity Data:
Stability: Stable
Hazardous Polymerization: Will not occur.
Incompatibility (Materials to Avoid): Acids
Hazardous Decomposition or Bi-Products: When exposed to acids a vigorous reaction results with the emission of toxic fumes of sulphur dioxide and sulphurous acid.

Section 8 Special Protection Information:
Ventilation: Mechanical exhaust required.
Respiratory Protection: Appropriate NIOSH/MSHA approved respirator.
Protective Gloves: Compatible chemical resistant gloves.
Eye Protection: Safety goggles.
Other Protective Clothing or Equipment: Apron and sleeves.

Section 9 Spill/Leak Procedures:
Steps to Be Taken in case Material is Released or Spilled:
Wear respirator, chemical safety goggles, rubber boots and heavy rubber gloves.
Absorb on inert absorbent, transfer to sealed container and arrange removal by disposal company. Avoid raising dust. Wash site of spillage thoroughly with water and detergent.
Waste Disposal Methods: Dissolve or mix material with combustible solvent and burn in a chemical incinerator with an after burner and scrubber. Observe all local, state and Federal laws.

Section 10 Special Precautions:
Precautions to Be Taken in Handling and Storing:
Irritating to eyes, respiratory system and skin.
Wear suitable protective clothing.

NA= Not applicable
NR= Not registered

Ted Pella, Inc. makes no warranty of any kind regarding the information furnished herein. Users should independently determine the suitability and completeness of information from all sources. While this data is presented in good faith and believed to be accurate, it should be considered only as a supplement to other information gathered by the user. It is the User's responsibility to assure the proper use and disposal of these materials as well as the safety and health of all personnel who may work with or otherwise come in contact with these materials.