Calibration Overview

SEM Specimen mounts selection for Calibration

Listed below are the available SEM specimen mounts for SEM test specimens and calibration standards. We have mounts available for most SEMs on the market which are listed in the table as A-R. If a SEM specimen selection is available with a test specimen or calibration standard (designed by the letter A-R after the product number), you can select the mount from the table below.

The test specimen of calibration standard is mounted on the selected SEM specimen mounts with conductive cement. All test specimens and calibration standards are normally mounted in the center of the specimen mounts. If a specific location other than the center is needed, order Mount G and supply a clear drawing for this custom mounting.

example of
specimen position


Type Prod. No.   Data (D=Head dia.; P=Pin dia.; PL=Pin (length)
A 16111 pin mount dim Pin Mount: D=12.7mm; P=3.2mm; PL= 7.9mm, FEI/Philips, Cambridge, Leica, TESCAN, CAMSCAN, ASPEX, Phenom
B 16261 pin mount Pin Mount: D=12.7mm; P=3.2mm; PL=14.3mm, AMRAY
C 16221 10mm cylinder 9.5mm dia. x 9.5mm Cylinder, JEOL
D 16281 15mm cylinder 15mm dia. x 15mm Cylinder, JEOL, ISI/ABT/TOPCON
E 16291 cylinder mount 15mm dia. x 10mm Cylinder, JEOL, ISI/ABT/TOPCON
F 16111-9 Pin Mount: 12.7mm x 3.2mm pin. PL=6mm, ZEISS/LEO SEMS FESEMs/FIBS
G     You Supply Mount or Mount of Your Choice, not listed here (contact customer service)
K 16324 specimen mount 15mm dia. x 6mm Cylinder, M4 Hitachi, Agilent / Keysight
L 16327 specimen mount 25mm dia. x 6mm Cylinder, M4 Hitachi, Agilent / Keysight
M 16231 12.5mm mount 12.2mm dia. x 10mm Cylinder, JEOL
O 16115 31.7mm dia. x 6.47mm, Cambridge S4 Mount
P 16242 12.7mm mount Pin Mount: 12.7mm dia. x 15.7mm height, AMRAY special slotted head
Q 16153 25 x 10mm cylinder mount 25mm dia. x 10mm Cylinder, JEOL
R 16144 25.4 x 10mm cylinder mount Pin mount: D=25.4mm; pin=3.2mm, FEI/Philips, Cambridge, Leica, TESCAN, CAMSCAN, ASPEX, Phenom